
Slide transitions
Your first slide show should probably have the same slide transition for
all slides. Setting
Advance slide
to On mouse click is the default and
a simple setting. If you want each slide to be shown for a specific
amount of time, click Automatically after and enter the number of
seconds. Click Apply to all slides.
Transition choices are found on the Tasks pane. For more information
about slide transitions, see Chapter 9 (Slide Shows).
Tip
The Slide transition section has a very useful choice:
Automatic
preview
. Select its checkbox. Then when you make any changes
in a slide transition, the new slide is previewed in the Slide
Design area, including its transition effect.
Running the slide show
To run the slide show, do one of the following:
• Click Slide Show > Slide Show on the main menu bar.
• Click the Slide Show button on the Presentation toolbar (Figure
13) or the Slide Sorter toolbar (Figure 5).
• Press
F5
or
F9
.
If the slide transition is
Automatically after x seconds
, let the slide
show run by itself.
If the slide transition is
On mouse click
, do one of the following to
move from one slide to the next.
• Use the arrow keys on the keyboard to go to the next slide or to
go back to the previous one.
• Click the mouse button to advance to the next slide.
• Press the
Spacebar
on the keyboard to advance to the next slide.
When you advance past the last slide, the message “Click to exit
presentation...” appears. Click the mouse or press any key to exit the
presentation.
To exit the slide show at any time, including at the end, press the
Esc
key.
Chapter 1 Introducing Impress 27
Comentarios a estos manuales